Electrical - Scotsman C1448R Manuel D'installation

Electrical

The machine is not supplied with a power cord, one
must be field installed.
Notice: In case the power cable is damaged, it
must be replaced ONLY by QUALIFIED
TECHNICIANS to prevent any possible risks
The dataplate on the back of the cabinet details the
power requirements, including voltage, phase and
maximum fuse size. Extension cords are not
permitted. Use of a licensed electrician is
recommended.
Power Cord Installation:
1. Select and obtain the proper power cord of type
H03RT-F, H05RR-F, H03VV-F, H03VVH2-F or
heavier. Ground wire must be green/yellow color.
Only one cord per plug. See Power Cord
Reference Table for suggested cord sizing.
2. Electrical supply circuit must be dedicated to this
machine. Do not connect to a circuit powering any
other device. Product should only have one supply
means.
Remote
Condenser
Electrical
Connection
Power Supply
Remote Condenser Models - Installation Manual
3. Remove the junction box cover.
4. Install a field supplied, non-detachable,
non-metalic strain relief per code. Strain relief must
be properly sized for the OD of the power cord and
the ID of the routing hole.
.
5. Route the power cord through the access hole /
strain relief and properly attach the power supply
wires. Do not tin the leads. Strip 6 mm of power
cord lead insulation and properly attach power cord
wires to the lead wires in the junction box.
6. Connect an electrical plug of the proper type for
the application and country of use.
Note: The plug will be the disconnect means for
this machine.
Attach a ground wire to the ground connection in
7.
the junction box. Note: Ground wire must be longer
than power lead wires.
Check voltage when complete.
8.
Electrical Connections
June 2007
Page 13
C1448, C1848, C2148
Condenser
Fan Motor
Junction
Box
Cover
Power Supply
Wires
Install
Strain
Relief
Ground W
Connecti
Install
Strain
Relief