Install Leveling Legs; Assemble Drawers - Gladiator Garageworks GAGD283DTG0 Instructions D'assemblage

Install Leveling Legs

®
The Gladiator Modular GearBox is designed to be either stationary
or to roll on casters. To order the Gladiator
Caster Kit, see "Accessories."
1. Place the cabinet on its side.
2. Screw a leveling leg (P7) into each of the four rivet nuts located at
the corners of the cabinet as shown.
P1
P6
P4
A. Leveling legs
3. Stand the cabinet upright.
4. If you have not already, fasten the two bolts at each front corner,
of the cabinet frame. Completely tighten all the cabinet bolts and
nuts.

Assemble Drawers

F3s Phillips-head screw (66 - silver)
IMPORTANT:
Position the drawer sides so that the glides are at the top and
facing the outside.
Do not fully tighten the six screws attaching the drawer back to
the sides.
1. Using Phillips-head screws (F3s), attach the side (D1) to the back
(D2) as shown.
NOTE: Working from the back, insert the screws through the
drawer back and then into the drawer side.
4
® Steel Modular GearBox
P7
A
F3s
2. Using Phillips-head screws (F3s), attach side (D3) to the back
(D2) as shown.
NOTE: Working from the back, insert the screws through the
drawer back and then into the drawer side. To allow for
adjustment when inserting the drawer glides into the cabinet do
not completely tighten screws.
D3
A
A. Do not completely tighten drawer screws
3. Working from the top, set the drawer bottom (D4) down onto the
back and side flanges as shown.
4. Working from the bottom, insert screws through the drawer back
and sides and then into the drawer bottom.
NOTE: Wait until the drawer front is in place before inserting the
screws that attach the drawer bottom to the front.
D1
5. Using Phillips-head screws (F3s), attach the drawer front (D5) to
the bottom and sides.
NOTE: The bottom flange of the drawer front (D5) fits under the
drawer bottom (D4).
D3
D2
A. Drawer glide lever
6. Before you insert the drawer into the cabinet, make sure the
bearing carriages on the cabinet slides are at the front of the
cabinet.
D1
D2
A
D4
D2
D3
D5
D4
D1
A