Assembly Instructions; Cabinet Use Requirements; Unpack Cabinet Parts; Assemble Cabinet - Gladiator Garageworks GAGD283DTG0 Instructions D'assemblage

Cabinet Use Requirements

Intended for use in a garage.
Maximum weight limit is 30 lbs (13.6 kg) for each drawer.
Maximum weight limit is 300 lbs (136 kg) for the cabinet.

Unpack Cabinet Parts

1. Remove and verify the contents. Contents include an Allen
wrench, and the parts and fasteners shown in "Parts."
2. Dispose of/recycle all packaging materials.

Assemble Cabinet

F1
⁵⁄₁₆
F1 " Allen-head bolt (24)
⁵⁄₁₆
F2 " Flange nut (24)
Gather the required tools before starting installation.
Tools Needed:
¹⁄₂" Wrench
³⁄₈" Wrench
Phillips screwdriver
Tools Supplied:
Allen wrench
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet or locker.
Failure to do so can result in back or other injury.
IMPORTANT:
Two people may be required to complete the assembly.
As you assemble the cabinet, make sure the edges with the
holes are facing up.
If you are assembling the cabinet on the floor, fasten the eight
front corner bolts, two at each corner, after you stand the cabinet
upright.
1. Place side panel (P1) on a flat, firm surface so that the edge with
the holes is facing up as shown.
2. Insert the cabinet top (P2) between the edges of side panel (P1).
NOTE: Make sure the edges with the holes are facing up.
3. Align the holes and attach the top (P2) to side panel (P1) using
Allen-head bolts (F1) and ⁵⁄₁₆" flange nuts (F2) as shown. Do not
tighten completely.

ASSEMBLY INSTRUCTIONS

F2
Pliers
Level
Tape measure
4. Position side panel (P3) so that the top (P2) is between the edges
of side panel (P3).
5. Align the holes and attach the top (P2) to the side (P3) using
Allen-head bolts (F1) and ⁵⁄₁₆" flange nuts (F2) as shown. Do not
tighten completely.
6. Insert cabinet bottom (P4) between the edges of side panels
(P1 and P3).
NOTE: Make sure the edges with the holes are facing up.
7. Align the holes and attach the bottom (P4) to the side panels
(P1 and P3) using Allen-head bolts (F1) and ⁵⁄₁₆" flange nuts (F2)
as shown.
P1
P2
8. Square the cabinet frame. The measurements from corner to
corner should be equal distance.
P1
P2
9. Using the Allen wrench (provided), completely tighten the bolts.
Measure the frame again to make sure it is still square.
P4
P3
P2
P4
P3
P3
3