Ambient Temperature - Honda WMP20XE Manuel De L'utilisateur

3. Fill with the
recommended oil
to the top of the oil
filler neck.
4. Screw in the oil
filler cap [1]
securely.
[1]
Engine Oil Recommendations
Use 4-stroke motor oil that meets or exceeds the requirements for API
service category SJ or later. Always check the API SERVICE label on
the oil container to be sure it includes the letters SJ or later.
SAE 10W-30 is recommended
for general use. Other
viscosities shown in the chart
may be used when the average
temperature in your area is
within the indicated range.
NOTICE
Using nondetergent oil can shorten the engine's service life, and using
2-stroke oil can damage the engine.
30
5W-30 • 10W-30
0 20 40 60 80 100°F
-20 -10 0 10 20 30 40°C

AMBIENT TEMPERATURE

Air Filter Inspection
1. Unscrew the outer wing nut [1] and remove the air cleaner cover
[2].
2. Remove the inner wing nut [3] and both air filter elements [4,5].
3. Separate the air filter elements and carefully check them for holes
or tears. Replace the filter elements if they are damaged.
4. Wipe dirt from the inside of the air cleaner housing and cover. Be
careful to prevent dirt from entering the air duct that leads to the
carburetor.
5. Install the foam element over the paper element, and install the
assembled air filter. Secure the air filter with the inner wing nut.
Make sure the rubber washer [6] is in place under the filter
elements.
6. Install the air cleaner cover, and secure with the outer wing nut.
NOTICE
Operating the engine without an air filter, or with a damaged air
filter, will allow dirt to enter the engine, causing rapid engine wear.
This type of damage is not covered by the Distributor's Limited
Warranty.
ENGLISH
[1]
[2]
[3]
[4]
[5]
[6]
9