Festo SDE5 Série Notice D'utilisation page 31

SDE5-...
6.3 Setting the SDE5-...-FP-... :
a) Mode selection (change from mode 1 to 3):
1. Switch on the operating voltage.
2. Press the EDIT button 1 at first once
briefly (less than 2 s).
When the button is released, the LED
shows the set mode five times one after
the other (e.g. 3 flashes for mode 3,
see second line in Fig. 19).
During the mode display (item 2):
3. Press the EDIT button 1 until the desired operating mode is shown.
The LED flashes an appropriate number of times to indicate the operating
modes 1 to 3 one after the other (see third line in Fig. 19).
When the EDIT button 1 is released, the SDE5-... programs itself to the last
displayed mode.
The following settings on the SDE5-...-FP-... are possible:
Mode selection
LED flashing
sequence (item 2)
LED flashing
sequence (item 3)
Fig. 19
Festo SDE-... 0204NH English
Mode 1 Mode 2
1
1
Hy
0 P
0
5x
SDE5-...-FP-...
Fig. 18
Mode 3
1
P
0
5x
1
P
5x
...
31