Festo SDE5 Série Notice D'utilisation page 28

SDE5-...
6 Commissioning
Please note
The SDE5-...-..X without EDIT button possesses a factory setting with fixed
switching pressures.
S Read further in the chapter "Operation."
The SDE5-...-..X does not require further adjustment.
With all other SDE5-... (with EDIT button 1 ):
Please note
Unintentional pressing of the EDIT button may cause a modification of the
preset switching pressure.
S Make sure that the EDIT button is only pressed intentionally.
Otherwise the SDE5-... will be set to a switching pressure of 0 bar, for
example if there is no operating pressure.
Definition
Pressure P =
Switching
pressure SP =
Teach pressure TP = operating pressure at time of programming
Run mode =
SDE5-...
Setting options
Instruction text
Fig. 13
28
relative pressure (also contains vacuum with SDE5-V..-...).
operating pressure at which the SDE5-... switches
basic status (achieved by switching the operating voltage
on and off )
-O-... -O1/O2/O3-...
-C-... -C1/C2/C3-...
--- ---
Switching pressure setting (teach)
Page 29 Page 30
-FP-...
Mode selection
Pages 31 and 32
Festo SDE-... 0204NH English