Ammann 11003438 Série Traduction Du Mode D'emploi Original page 80

6. Main ten an ce
6.6.5 Scrap ers
Ex am ine the scrap ers for wear and po si tion rel a tive to roller.
Ad just ment:
• Loosen hexa gon head screws (1).
• Shift the scrap ers (2) to wards the roller.
• The scrap ers should be set at a dis tance of 1.5 – 2 mm from
and par al lel to the roller.
• Tighten hexa gon head screw.
6.6.6 Wa ter spray ing sys tem
Clean wa ter tank when nec es sary:
• Dis man tle stop cock (1).
• Rinse out wa ter tank with pow er ful wa ter jet.
• Re fit stop cock, us ing new seal if nec es sary.
• Switch on the spray ing sys tem briefly in or der to rinse out the
pipework.
75