Section 3: Receiver Programming; Quick Enroll Wireless Devices; Keypad Slot Assignment - DSC TR5164 Instructions D'installation

Enrollment consists of programming the device's Electronic Serial Number (ESN) into the TR5164 so it
can be identified when an event is communicated. The ESN is located on the back of each device.
This section describes how to enroll and program:
• wireless devices using zones
• wireless keys
For more information, read the instruction sheet included with each device.
3.1 Enroll the Wireless Keypad On The TR5164
During initial power-up of the alarm panel, a 2-minute window is established for enrolling the wireless
keypad (indicated by flashing red and green LEDs). If the enrollment window expires, power down the
panel then power it up again. By default, WT5500 keypads are automatically assigned to slot numbers
8, 7, 6, 5.
To enroll a keypad:
1. Power up the alarm system.
2. Power up the keypad. After a few seconds, "Hold [1] and [
3. Press the [1] and [
If the "Failed to Enroll" message is displayed, perform the following:
• Retry the enrollment.
• Reposition the keypad closer to the control panel.
• Verify that the red and green indicators are flashing on the TR5164. If not, disconnect the panel from
AC and DC power sources then reconnect.
• Check for RF interference. If the yellow LED is lit, RF traffic or noise floor level is too high.
NOTE: Set the zone definitions for wireless keypad slots as type 26 - 24Hr Non-Alarm.
3.2 Quick Enroll Wireless Devices/Keypads (WT5500 only)
1. Enter [ ][8][Installer Code][898]. "Wireless Enrollment Mode" is displayed.
,
2. Activate the device as indicated below.
• Keypad: Press the [
• Wireless key: Press any key to activate.
• Detectors (PIR, Smoke, Glass break): Press the Tamper button.
• Repeater: Press the Tamper button. Note: Ensure that dip switch 3 on the repeater is in the off
position before quick enrolling a repeater.
3. The Electronic Serial Number (ESN) is displayed on the keypad. Press [
the ESN is incorrect, press [#] then repeat step 2.
4. After successful confirmation of the ESN, the system prompts for the zone/slot number.
• The next open slot for the device type is displayed. Press [
• To re-enroll a wireless key on another system, press
3.3 Change Keypad Slot Assignment
To change the default slot number for a WT5500 keypad:
1. Enter Installer Programming [
2. Enter section [804][000]. A 2-digit field is displayed.
3. In the first field, enter 1 for Partition 1 (only Partition 1 is supported). In the second field, enter a
keypad slot number from 1-8 (e.g., 1,8 represents Partition 1, keypad slot 8).
4. Record the assigned slot number in the programming worksheets at the back of this manual.

Section 3: Receiver Programming

] keys together to enroll. "WFKP Enrollment Successful" is displayed.
,
] and [1] keys at the same time.
,
][8][installer code].
,
] to Enroll Keypad" is displayed.
,
] to accept or key in another slot.
,
together for 3 seconds.
6
] to confirm the ESN. If
,