Controls & Indicators - DSC TR5164 Instructions D'installation

1.2 Controls and Indicators
TR5164 LEDs
LEDs 3, 4, and 5 provide feedback regarding the installation, operation and troubleshooting of the
TR5164. The LEDs function as follows:
LED Normal Operation
#3 Flashes when
(red) receiving signals from
non-enrolled devices.
#4 Flashes when
(green) receiving signals from
enrolled devices.
#5 On when RF
(yellow) interference is high.
Off or flashing when
RF interference is
low.
Tamper
The TR5164 has separate built-in wall and case tampers. The tampers are disabled by default on the NA
version (enabled on EU version). Section [804][900] options 3 and 4 enable or disable the tampers.
When the TR5164 is properly installed, the wall tamper on the back of the unit should be depressed by
the mounting surface. If the unit is removed, the tamper activates. The case tamper activates when the
case is opened and restores when the case is closed.
For proper unit tamper operation, the surface that the TR5164 is mounted to should be smooth and free
of obstructions that block access to the rear of the unit. Ensure that electrical wires do not run over and
under the module when it is mounted.
NOTE: The built-in wall and case tamper must be installed and enabled for UL/ULC Listed
Commercial Burglary applications.
Placement Test Mode
Flashes when
receiving signals from
all devices except the
one being tested.
Flashes when
receiving signals from
the specific device
being tested.
On when RF
interference is high.
Off or flashing when
RF interference is
low.
4
2-Minute Startup
Flashes during 2-
minute enrollment
window.
Note that signals
received from non-
enrolled devices are
not indicated in this
mode.
Flashes during 2-
minute enrollment
window.
Note that signals
received from
enrolled devices are
not indicated in this
mode.
On when RF
interference is high.
Off or flashing when
RF interference is
low.
Keybus Fault
On when keybus fault
condition is present.
On when keybus fault
condition is present.
On when RF
interference is high.
Off or flashing when
RF interference is
low.