Cleaning The Tool - Makita DUM111 Manuel D'instruction

Hold the tool with one hand, pull the switch trigger while
pressing the lock-off button, and then move it forward.
For basic operation, tilt the blades toward the trimming
direction and move it calmly and slowly at the speed
rate of 3 to 4 seconds per meter.
To tie a string at the desired height and to trim along it
help you to cut a hedge top evenly.
If the chip receiver is attached to the blades, it gathers
discarded leaves and makes clean-up afterward much
easier.
To cut a hedge side evenly, cut from the bottom to top.
When trimming to make a round shape (trimming box-
wood or rhododendron, etc.), trim from the root to the
top for a beautiful finish.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

Cleaning the tool

Clean the tool by wiping off dust with a dry cloth or one
dipped in soapy water and wrung out.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
18 ENGLISH