Makita DUM111 Manuel D'instruction page 13

7.
Place the undercover so that
cover is aligned with
► 1 . Undercover 2. Lock lever
8. While pressing the undercover, turn the under-
cover clockwise until
with on the lock lever.
► 1 . Undercover 2. Lock lever
9. Make sure that the lock lever fits in the groove on
the undercover.
1
► 1 . Lock lever
CAUTION:
Never use the tool without install-
ing the undercover.
10. Remove the blade cover, and then turn on the tool
to check that it works properly.
NOTICE:
If the shear blades do not operate prop-
erly, the blades are not engaging the crank prop-
erly. Remove the blades and install them again.
on the under-
on the lock lever.
1
on the undercover is aligned
1
Installing or removing shear blades
for hedge trimmer
2
CAUTION:
removing or installing the shear blades.
NOTICE:
If the parts other than the shear blades
such as the crank are worn out, ask Makita
Authorized Service Centers for parts replacement
or repairs.
Removing the shear blades
1. Place the tool upside down.
2
2.
While pressing the lock lever, turn the undercover
counterclockwise until
with on the lock lever.
► 1 . Lock lever 2. Undercover
13 ENGLISH
Attach the blade cover before
on the undercover is aligned
1
2