Drum Light - AEG LAVATHERM 75175AV Notice D'utilisation

38
Door does
not close
Err (Error)
on the dis-
5)
play.
No drum
6)
light
Abnormally
elapsing
time on the
5)
display
Drying cycle
too short
Drying cycle
too long
1) In case of error message on the display (e.g. E51- only tumble dryer with the display):
Switch the tumble dryer off and on. Set programme. Push the Start/Pauze (Start/Pause)
button. Does not work? - inform local service and quote the error code.
2) follow programme recommendation - see PROGRAMMES chapter
3) see CARE AND CLEANINGchapter
4) see section MACHINE SETTINGS in HINTS AND TIPS chapter
5) only dryers with the display
6) Only dryers with drum light.
7) Note: After maximum 5 hours the drying cycle ends automatically (see Drying cycle
complete section).

DRUM LIGHT

Only use a special bulb which is de-
signed specially for tumble dryers. The
special bulb can be obtained from your
local service centre.
WARNING!
When the appliance is switched
on, the interior lighting switches
itself off after 4 minutes when
the door is open.
High water hardness.
Filter not locked in position.
Laundry locked between the
door and the seal.
Attempt to change parameters
after start of the programme.
The function you set is not ap-
plicable with the set programme
Defective drum light.
Time to end is calculated on the
basis of: type, volume and
dampness of laundry.
Small laundry volume./Too dry
laundry for selected pro-
gramme.
The filter clogged.
Too high volume of the load.
7)
Laundry insufficiently spun.
Very high room temperature -
no appliance fault.
Set applicable water hardness
Put the filter in the correct posi-
tion.
Put the load correctly in the
drum.
Turn the tumble dryer off and
on. Set requested parameters.
Turn the tumble dryer off and
on. Set requested parameters.
Contact the service centre to re-
place the drum light.
Automatic procedure; this is not
a appliance fault.
Select time programme or high-
er drying level (e.g. Extra Droog
(Extra dry) ).
Clean the filter.
Respect the maximum load vol-
ume.
Spin adequately the laundry.
Lower the room temperature if
possible.
WARNING!
Do not use standard bulbs!
These develop too much heat
and may damage the appliance!
Before you replace the bulb,
disconnect the mains plug; with
a permanent connection: fully
unscrew or deactivate the fuse.
1. Unscrew cover above the bulb (this
can be found directly behind the
loading aperture, at the top; refer to
4)
.