AEG LAVATHERM 75175AV Notice D'utilisation page 42

42
WARNING!
It is important not to connect
the vent hose to, for example, a
cooker hood, or a chimney or
flue pipe designed to transmit
the exhaust from a fuel burning
appliance.
Note that to prevent condensation
problems, it is essential that the dryer
be installed with the flexible hose to
transmit its "exhaust" at least beyond
the kitchen units; preferable outside the
kitchen. In order to prevent the appli-
ance from overheating, it is important
that the steam exhaust is unobstructed.
Thus, if a permanent hose installed to
an external wall or ceiling, it must be
ensured an exhaust capacity of mini-
mum 150 m3/h. If the dryer is installed
adjacent to kitchen units, make sure
that the vent hose is not squashed. If
the hose is not fully squashed, drying
efficiency will be decreased , resulting
in longer drying times and higher ener-
gy consumption. If the hose is fully
squashed, the automatic cut-outs with
which the appliance is fitted can oper-
ate. When operating the tumble dryer,
the room temperature must not be low-
er than +5°C and higher than +35°C, as
it can affect the performance of the ap-
pliance.
THE LOAD DOOR REVERSAL
WARNING!
Before changing the door stop,
disconnect the mains plug.
1. Open load door.
2. Unscrew hinge A from the front of
the appliance and remove the load
door.
3. Remove cover plates B. To do this,
put a thin screwdriver into the slots
as shown in the illustration, push
down lightly and remove the cover
plates.
A
A
4. Use an applicable tool and apply
pressure to unlock part C, remove
and turn it through 180°, then put
on the other side.
CAUTION!
There is a small spring below
locking block C. To put all parts
together correctly, look at the il-
lustrations:
B
C
B