AEG LAVATHERM 75175AV Notice D'utilisation page 41

3. Remove foil hose and polystyrene
padding from the machine.
THE VENT HOSE
INSTALLATION
There are 3 vent outlets: on the
left, right side and at the rear.
1. Pull the ring nut A from the vent
outlet at the rear.
2. Screw on the ring nut to the hose
and push it into position.
3. The not used vents must be sealed
with supplied covers.
If the hose is long and the room
temperature low, the moisture
might condense to water inside
the hose. This is an usual occur-
rence. To prevent this water
from the hose, it is recommend
to drill a small hole (via. 3 mm) in
the lowest point of the hose and
to put a small container below
it. (See picture, point B).
Make sure that the vent hose
length is less than 2 m, and that
it contains no more than 2
bends.
As to the outlet itself, if you have deci-
ded on a install wall/window grille, a
good local builder's merchant can sup-
ply you with the necessary fittings and
installation advice.
ENGLISH 41