36
–
cm
–
300-600 μS/cm
–
μS/cm
3. Push the Start/Pauze (Start/Pause)
button again and again until you set
necessary level.
4. To memorise setting push at the
same time the A and B buttons
Zoemer (Buzzer) permanent off
CARE AND CLEANING
CLEANING THE FILTER
At the end of each cycle the filter indi-
cator is on to tell you that the filter must
be cleaned.
The filter collects the fluff. The
fluff occurs while the cloths are
dried in the tumble dryer.
1. Open the door.
2. Pull the filter.
3. Open the filter.
low conductivity <300 μS/
medium conductivity
high conductivity >600
B
A
1. Turn the programme dial to one of
programmes.
2. Push at the same time the A and B
buttons and hold down for approxi-
mately 5 seconds.
3. The buzzer is by default always off.
4. Use a moist hand to clean the filter.
5. If necessary clean the filter with
warm water using a brush.
Close the filter.