Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
18 www.aeg.com
1) In case of error message on the display (e.g. E51- only tumble dryer with the display):
Switch the tumble dryer off and on. Set programme. Push the Start/Pause button. Does not
work? - inform local service and quote the error code.
2) follow programme recommendation - see PROGRAMMES chapter
3) see CARE AND CLEANINGchapter
4) see section MACHINE SETTINGS in HINTS AND TIPS chapter
5) only dryers with the display
6) Only dryers with drum light.
7) Note: After maximum 5 hours the drying cycle ends automatically (see Drying cycle
complete section).
DRUM LIGHT
Only use a special bulb which is designed
specially for tumble dryers. The special
bulb can be obtained from your local
service centre.
WARNING!
When the appliance is switched
on, the interior lighting switches
itself off after 4 minutes when the
door is open.
WARNING!
Do not use standard bulbs! These
develop too much heat and may
damage the appliance! Before
you replace the bulb, disconnect
the mains plug; with a permanent
connection: fully unscrew or deac-
tivate the fuse.
1.
Unscrew cover above the bulb (this
can be found directly behind the
loading aperture, at the top; refer to
"PRODUCT DESCRIPTION" chapter.)
2.
Replace defective bulb.
3.
Screw cover back down.
Check the correct positioning of o-ring
gasket before screwing back the door
light cover. Do not operate the tumble
dryer when missing o-ring gasket on door
light cover.
WARNING!
For safety causes , the cover must
be screwed down tightly. If this is
not done, the tumble dryer must
not be operated.
SERVICE
If there are technical faults, first check if
you can remedy the problem yourself with
the help of the operating instructions -
see section TROUBLE SHOOTER
If you cannot remedy the problem on your
own, get in touch with the Customer Care
Department or one of our service part-
ners.
To assist you quickly, these data are nec-
essary:
– Model name
– Product number (PNC)
– Serial number (Ser. No. is on rating
plate attached to the product - to find it
see chapter PRODUCT DESCRIPTION))
– Type of failure
– Any error messages shown by the dis-
play.
So that you have the necessary reference
numbers from your appliance at hand, we
recommend that you write them in here:
Mod.
.................................
PNC:
.................................
Ser. No.
.................................
Publicité
Chapitres
Table des Matières
