AEG LAVATHERM 65179AV Notice D'utilisation page 22

22 www.aeg.com
is installed adjacent to kitchen units, make
sure that the vent hose is not squashed. If
the hose is not fully squashed, drying effi-
ciency will be decreased , resulting in lon-
ger drying times and higher energy con-
sumption. If the hose is fully squashed,
the automatic cut-outs with which the ap-
pliance is fitted can operate. When oper-
ating the tumble dryer, the room temper-
ature must not be lower than +5°C and
higher than +35°C, as it can affect the
performance of the appliance.
THE LOAD DOOR REVERSAL
WARNING!
Before changing the door stop,
disconnect the mains plug.
1. Open load door.
2. Unscrew hinge A from the front of the
appliance and remove the load door.
3. Remove cover plates B. To do this,
put a thin screwdriver into the slots as
shown in the illustration, push down
lightly and remove the cover plates.
A
A
4. Use an applicable tool and apply
pressure to unlock part C, remove
and turn it through 180°, then put on
the other side.
CAUTION!
There is a small spring below lock-
ing block C. To put all parts to-
gether correctly, look at the illus-
trations:
B
C
5. Unscrew hinge A from the load door
B
and turn it through 180°, then put on
the opposite side and screw down.
6. Turn cover plates B through 180° and
put them on the opposite side.
7. Unscrew cover plates D from the front
of the appliance, turn through 180°
and screw down on the opposite side.