AEG LAVATHERM 65179AV Notice D'utilisation page 21

2. Screw on the ring nut to the hose and
push it into position.
3.
The not used vents must be sealed
with supplied covers.
If the hose is long and the room
temperature low, the moisture
might condense to water inside
the hose. This is an usual occur-
rence. To prevent this water from
the hose, it is recommend to drill
a small hole (via. 3 mm) in the low-
est point of the hose and to put a
small container below it. (See pic-
ture, point B).
Make sure that the vent hose
length is less than 2 m, and that it
contains no more than 2 bends.
As to the outlet itself, if you have decided
on a install wall/window grille, a good lo-
cal builder's merchant can supply you with
the necessary fittings and installation ad-
vice.
WARNING!
It is important not to connect the
vent hose to, for example, a cook-
er hood, or a chimney or flue pipe
designed to transmit the exhaust
from a fuel burning appliance.
Note that to prevent condensation prob-
lems, it is essential that the dryer be in-
stalled with the flexible hose to transmit
its "exhaust" at least beyond the kitchen
units; preferable outside the kitchen. In
order to prevent the appliance from over-
heating, it is important that the steam ex-
haust is unobstructed. Thus, if a perma-
nent hose installed to an external wall or
ceiling, it must be ensured an exhaust ca-
pacity of minimum 150 m3/h. If the dryer
ENGLISH
21