Installation; Appliance Positioning - AEG LAVATHERM 65179AV Notice D'utilisation

20 www.aeg.com

INSTALLATION

APPLIANCE POSITIONING

• The tumble dryer must be installed in a
clean position, where dirt does not col-
lect.
• Air must flow freely around the appli-
ance. Make sure that the front airflow
slots in the bottom of the appliance are
not blocked .
• To keep vibration and noise at the mini-
mum, when the tumble dryer operates,
it must be put on a stable and flat sur-
face.
• When the appliance is put in its perma-
nent position, check if is fully level with
the aid of a spirit level. If it is not, adjust
the feet until it is.
• Do not remove the feet. Do not de-
crease the floor clearance through thick
carpets, bar of wood or equivalent. This
can increase the heat which can cause
interference with the operation of the
appliance.
• The temperature of the hot air
• When the tumble dryer oper-
• If it is necessary to move the ap-
• The appliance must not be in-
UNPACKING
CAUTION!
which occurs in the tumble dry-
er can increase to 60 °C. The
appliance must not be installed
on the floor which is not resist-
ant to high temperatures.
ates, the room temperature
must not be lower than +5 °C
and higher than +35 °C. This
can cause unwanted effect on
the performance of the appli-
ance.
pliance, it must be moved verti-
cally.
stalled behind a lockable door,
a sliding door, a door with a
hinge on the opposite side to
that of the appliance in such a
way that a full opening of the
tumble dryer is restricted.
Before use all parts of the transport pack-
aging must be removed.
1. Open loading door.
2. Pull off adhesive strips from inside
machine on top of drum.
3. Remove foil hose and polystyrene
padding from the machine.
THE VENT HOSE
INSTALLATION
There are 3 vent outlets: on the
left, right side and at the rear.
1. Pull the ring nut A from the vent out-
let at the rear.