Applications; Standard Accessories; Battery Removal/Installation - Hitachi DS 14DSL Mode D'emploi

English
CHARGER
Model UC18YRSL
Charging voltage
Weight

STANDARD ACCESSORIES

1 Plus driver bit (No.2) .................... 1
2 Charger (UC18YRSL or UC18YFSL) ....... 1
DS14DSL
3 Battery .............................................. 2
DS18DSL
4 Plastic case ....................................... 1
5 Battery cover .................................... 1
DS14DSL
Charger, Battery, Plastic case and
(NN)
Battery cover are not contained.
DS18DSL
(NN)
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
Battery
(BSL1430) (BSL1415)
(BSL1440) (BSL1425)
(BSL1450)
Optional accessories are subject to change without notice.
Before
charging
While
charging
Charging
complete
The pilot
lamp
lights or
Charging
blinks.
impossible
Overheat
standby
10
UC18YFSL
14.4 V – 18 V
0.6 kg 0.5 kg
(BSL1825)
(BSL1830)
(BSL1840)
(BSL1850)
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light for 0.5
Blinks
seconds. (off for 0.5 seconds)
(red)
Lights continuously
Lights
(red)
Lights for 0.5 seconds. Does not light for 0.5
Blinks
seconds. (off for 0.5 seconds)
(red)
Lights for 0.1 seconds. Does not light for 0.1
Flickers
seconds. (off for 0.1 seconds)
(red)
Lights
Lights continuously
(green)
〈UC18YRSL〉
Lights for 1 seconds. Does not light for 0.5
Blinks
seconds. (off for 0.5 seconds)
(red)
〈UC18YFSL〉

APPLICATIONS

Driving and removing of machine screws, wood
screws, tapping screws, etc.
Drilling of various metals
Drilling of various woods

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Figs. 1 and 2).
CAUTION:
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see Fig. 2).
CHARGING
Before using the driver drill, charge the battery as follows.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
2. Insert the battery into the charger.
Firmly insert the battery into the charger, as shown
in Fig. 3, 4.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously
in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or
the rechargeable battery.
Table 1
Malfunction in the
battery or the charger
Battery overheated.
Unable to charge.
(Charging will commence
when battery cools)