Sony LMD-3251MT Instructions D'utilisation page 86

COMPUTER DETECT
USER CONFIG COMPUTER DETECT
DV I :
H D 1 5 :
Submenu Setting
COMPUTER The appropriate preset memory is set for
DETECT the signal from DVI and HD15 input
connector. Select "PRESET1" for the
standard computer signal. Select
"PRESET2" to "PRESET8" when the
computer signal is not standard (on
page 94).
The preset memory is set for each input
connector of DVI and HD15.
Note
"PRESET7" and "PRESET8" will only
be displayed when "DVI" is selected.
OPTION DVI SETTING
* These settings are displayed only when a BKM-256DD is installed
and an input signal from BKM-256DD is selected.
USER CONFIG – OPTION DVI SETTING
OPTION DVI SETTING
E X T 5 V ( I N ) :
E X T 5 V ( O U T ) :
E D I D U P D AT E :
E D I D S TAT U S :
M O D E L
S E R .
Submenu
EXT 5V(IN)
EXT 5V(OUT)
EDID UPDATE
86
Adjustment Using the Menus
xxxxx
xxxxx
xx
xx
xxxxx
xxxx
Setting
Selects ON to output external 5 V
power from the DVI input
connectors and OFF not to output.
Selects ON to output external 5 V
power from the DVI output
connectors and OFF not to output.
Downloads the EDID information
from the main unit (the monitor) to
the BKM-256DD. Select "START,"
and then press the ENTER button to
start downloading the EDID
information automatically. During
download, "EDID UPDATING..."
is displayed and the CONTROL
button cannot be operated. When
download finishes correctly,
"COMPLETE!" is displayed. When
a fault occurs, "ERROR" is
displayed. Press the RETURN
button to display the on-screen
menu.
Submenu Setting
EDID STATUS The information downloaded to the
BKM-256DD from the EDID of the
main unit (the monitor) is
displayed.
• MODEL: Model name of the
• SER.: Serial number of the
3D SETTING
* This setting menu is displayed only when input from BKM-
250TGM or DVI is selected.
* Only 2D/3D SELECT is displayed when DVI input is selected.
* Install BKM-250TGM to display HD-SDI signal in 3D.
* The IN (INPUT)-1 connector on BKM-250TGM can be used for
left signal input, and the IN (INPUT)-2 connector for right signal
input.
* 720/50p and 720/60p signals are displayed in the NATIVE scan
mode.
USER CONFIG – 3D SETTING 1/2
2 D / 3 D S E L E C T :
3 D S I G N A L F O R M AT :
D I S PA R I T Y S I M . :
H O R O P T E R C H E C K :
L E F T :
R I G H T :
F L I P H :
PAY L O A D I D I N - 1 : xx
USER CONFIG – 3D SETTING 2/2
2 D / 3 D D I S P L AY:
Submenu Setting
2D/3D SELECT Switches between 2D and 3D display
mode.
• 2D: Displays input signals for 2D
display mode.
• 3D: Displays input signals for 3D
display mode.
monitor
monitor
xx
xxxx
xxx
xx
xx
xxxx
xxxx
xxx
I N - 2 : xx
xx