Preparing The Unit (Rt880 Only); Attaching The Seal For The Cab Roof - Dometic WAECO CoolAir RT880 Notice De Montage

Installation
7.2.2

Preparing the unit (RT880 only)

A
NOTICE!
During preparatory work on the surfaces, secure the unit from falling
down.
Make sure that the work surface is clean and level to ensure that the unit
is not damaged.
➤ Place the air conditioning roof unit on a work surface with the housing
facing down.
A
NOTICE!
Screw in the thread insert vertically.
Do not exceed the screw torque of
 8 Nm for M6
 10 Nm for M8
➤
Screw in the 8 self-threading M8 thread inserts in the blind holes
marked with "1" (fig. 3 1, page 4).
Use the supplied 1/4" bit for this.
➤ Screw in the 4 self-threading M6 thread inserts in the corresponding
blind holes on the left and right of the outlet unit as shown in fig. 3 2,
page 4.
Use a 5 mm hexagon bit for this.
7.2.3

Attaching the seal for the cab roof

A
NOTICE!
Ensure that the adhesive surface for the seal between the unit and the
cab roof is clean (free of dust, oil, etc.).
➤ Stick the 2.5 m insulating tape (10 x 20 mm) to the cab roof, following
the outline of the sunroof opening (fig. 4, page 4).
➤ Provide the abutting edge and the top edge of the insulating tape with
an unhardened plastic butyl sealing compound (e.g.
SikaLastomer-710).
44
CoolAir RT880, SP950T
EN