Remote Control - Last Calor EVA 2016 Manuel D'installation, D'utilisation Et D'entretien

4.6.3 Menu M3 – select language
With this selection it is possible to set the desired language from those available.
4.6.4 Menu M4 – standby mode
Entering with button P3 and adjusting with buttons P1 and P2 you can activate or deactivate the STAND-BY mode.
By selecting ON in STANDBY mode the corresponding symbol on the display lights up and the stove shuts down
automatically when the room temperature has reached the set value for a given time.
The next restart in automatic will be possible only when the room temperature falls below the set value by a few
degrees (default 2°C). With the OFF selection, the modulation function is active but not the STANDBY mode.
Therefore when the temperature exceeds the set value the stove will operate at minimum power.
4.6.5 Menu M5 – buzzer
With this selection it is possible to activate or deactivate the stove alarm buzzer.
In order to activate or deactivate press the buttons P1 and P2, to confirm press button P3.
4.6.6 Menu M6 – initial loading
It allows the preloading of pellets for a given time. This function can only be activated when the stove is off and cold
and is used if the auger is empty due to no more pellets.
Once the menu is selected, push the button P2 to activate the auger at its maximum speed for a preset time. In
order to stop it, push button P3.
4.6.7 Menu M7 – stove status
This selection is reserved exclusively for the authorised service centre technician.
4.6.8 Menu M8 – settings by technician
This selection is reserved exclusively for the authorised service centre technician.
Modification of the technical parameters of menu 08 must be done by an authorised and competent technician; any
modifications made randomly can cause serious damage for which he constructor declines any liability.
4.6.9 Menu M9 – exit
By selecting this menu and then pushing button P3 you exit the menus and go back to the normal visualisation.

4.7 Remote control

The remote control works with the settings made in the control panel and allows stove lighting-shutdown, and
adjustment of the required output and temperature.
Since this device transmits through an infrared diode, it must be pointed at the receiver unit in the control panel.
The remote control allows the following operations:
P1 and P3: Buttons to set the power
level
P5: Button to activate/deactivate the
COMFORT function
power level activation)
P7: Button to activate/deactivate the
MAGIC CLEANING function
P9: On/Off button and for exiting the
MENU
(minimum
P2 and P4: Buttons to set the room
temperature
P6: Button to activate/deactivate the
QUICK function
P8: Button to activate/deactivate the
TURBO function
P10: Button to enter the MENU
35 EVA-2016