Remote Control - Last Calor EVA Manuel D'installation, D'utilisation Et D'entretien

4.6.4 Menu 04 – select language
With this selection it is possible to set the desired language from those available.
4.6.5 Menu 05 – standby mode
By selecting ON in STANDBY mode the corresponding symbol on the display lights up and the stove shuts down
automatically when the room temperature has reached the set value for a given time.
The next restart in automatic will be possible only when the room temperature falls below the set value by a few
degrees (default 2°C). With the OFF selection, the modulation function is active but not the STANDBY mode.
Therefore when the temperature exceeds the set value the stove will operate at minimum power.
4.6.6 Menu 06 – buzzer
With this selection it is possible to activate or deactivate the stove alarm buzzer.
4.6.7 Menu 07 – initial loading
Allows the preloading of pellets for a given time. This function can only be activated when the stove is off and cold
and is used if the auger is empty due to no more pellets. It is started with button P1 and stops with button P4.
4.6.8 Menu 08 – stove status
This selection is reserved exclusively for the authorised COLA service centre technician.
4.6.9 Menu 09 – settings by technician
This selection is reserved exclusively for the authorised COLA service centre technician.
Modification of the technical parameters of menu 09 must be done by an authorised and competent
technician; any modifications made randomly can cause serious damage for which COLA declines any
liability.
4.6.10 Menu 10 – settings by technician
This selection is reserved exclusively for the authorised COLA service centre technician.
4.6.11 Menu 11 – ECO mode
The selection ON in the ECO mode limits the stove to operate in modulation, i.e. at minimum power and minimum
ventilation. The display shows NIGHT ECO and the corresponding symbol lights up.

4.7 Remote control

The remote control is a device that transmits through an infrared diode. Therefore it must be pointed towards the
receiver unit fitted in the control panel.
The remote control allows the following operations:
P1 and P3: Buttons to set the power
level
P5: Button for accessing the MENU
P7: Button to activate/deactivate
ECO mode (activation
power)
P9: On/Off button and for exiting the
MENU
minimun
P2 and P4: Buttons to set the room
temperature
P6: Button to exit the MENU
P8: Button to activate/deactivate
STANDBY mode
P10: Button to activate/deactivate
the CHRONO function
40 EVA-