Protective Equipment; Before Use; Side Handle - Hilti DD 130 Mode D'emploi

5.2.6 Protective equipment

Never use the tool without the applicable protective
equipment:
G Never operate the tool without the water swivel /
extraction head.
G An additional means of securing the drill stand must
be employed when used for horizontal drilling with vac-
uum attachment.
G The drill stand must be fastened by means of an
anchor or quick-release brace when used for overhead
drilling.
G Use of the water collector system in conjunction
with a wet-type vacuum cleaner is mandatory when
carrying out wet overhead drilling.
Printed: 08.07.2013 | Doc-Nr: PUB / 5069520 / 000 / 01

6. Before use

It is essential that the safety precautions printed in these
operating instructions are read and observed.
-CAUTION-
Disconnect the tool from the mains supply.
If extension cables are used: Only extension cables of a
type approved for the intended use and of adequate cross
section may be used. Failure to observe this point may
result in reduced performance and could cause the cable
to overheat. Damaged extension cables must be replaced.
The recommended cable cross-sections and maximum
lengths are:
Conductor cross-section
Mains voltage 1.5 mm
100 V
110–120 V 20 m
220–230 V 50 m
I The tool, the diamond core bit and the
drill stand are heavy.
I There is a risk of pinching parts of the
body.
I Wear a safety helmet, safety gloves and
safety boots.

6.1 Side handle

6.1.1 Fitting the side handle
1. Screw the side handle onto the tool and tighten it
securely.
6.1.2 Fitting the side handle in a different position
1. Remove the screw plug at the position where the side
handle is to be fitted (e.g. for left-handed use). The
grip at the end of the side handle can be unscrewed
and used as a screwdriver.
2. Screw the side handle onto the tool at the desired
position and tighten it securely.
3. Insert the screw plug in the exposed threaded hole.
6.1.3 Adjusting the extraction head / water swivel (and
side handle)
1. Press the water swivel lock out of the gap between
the locking ring and the water swivel/extraction head.
2. Release the locking ring between the chuck and side
handle.
2 2.0 mm 2 2.5 mm 2 3.5 mm
20 m 40 m
40 m
80 m
- CAUTION -
2
21