Instructions For Assembly; Technical Data - Hailo G60 Mode D'emploi

6. Instructions for assembly

(See illustrations on page 123 - 127)
6.1 Advance note
A) Function of the safety joint
To adjust the ladder frame [1], release the safety
swivel joint [Y] from the locked position as shown
and swivel the top part of the ladder frame
upwards by 180°. Both parts of the ladder frame
engage again automatically.
B) Positioning of the
cross-bars / ladder frames
Arrange both ladder frames [1] such that the
safety joint[Y] points to the inside when in the
position for use. Both cross-bars [10] are mounted
to the ladder frames from the outside.

Technical data /

6.2
Mounting variants
A) = Scaffolding dimensions.
Maximum installation height of the
work platform = 2,33 m.
B) = Standing heights and working heights with
different mounting variants of the scaffold
C) = Standing heights, working heights and
dimensions when using the ladder frames as
stepladder or single ladder.
6.3 Pre-assembly
A) Preparing the work platform
Insert cover cap [6] and pre-assemble 2 clip bolt
sets [7], [8], [9] on the work platform (offset
diagonally).
22
B) Assembly of the cross bars
1. Ladder frame without castors.
Fixing the foot [11] to the cross bar.
Mount the cross bar [10] to the bar of the
ladder frame [17], [18], [19|.
2. Ladder frame with castors.
Fixing the foot [11] to the cross bar.
Fix the cross bar with castor set [13], [14], [15],
[16] to the bars of the other ladder frame [17],
[18], [19|.
WARNING
Danger of severe injuries
in the event of a tipping over
In order to guarantee stability, the scaffolding
must only be used with the crossbars installed.
Assembly of the
6.4
multipurpose scaffolding
A) Assembly of the horizontal and railing braces
B) Assembly of the diagonal braces
Advance note:
all braces of the scaffolding [2], [3], [4] are
secured to the ladder frame using the same locking
system. Observe the positioning of the braces (see
figure).
1. Swivel securing hooks [X] away.
2. Insert rubber plugs of the pre-assembled
locking system into the hollow space of the
ladder rungs.
3. Swivel securing hooks [X] away to secure the
brace to the ladder frame.