Hailo G60 Mode D'emploi page 21

Warning, electricity hazard.
Identify any electrical risks in the
work area, such as overhead lines or
other exposed electrical equipment
and do not use the ladder where
electrical risks occur.
Use non-conductive ladders for unavoidable live
electrical work.
Do not use the ladder as a bridge.
Do not modify the ladder design.
Do not move a ladder while standing on it.
For outdoor use caution to the wind.
The crossbar ot the ladder
must be installed by the user
before the first use.
(see 6. Instructions for assembly)
Leaning ladders with rungs shall be
used at the correct angle.
Ladders used for access to a higher
level shall be extended at least
1 m above the landing point and
secured, if necessary.
Ladder for
non professional use.
Only use the ladder in the direction
indicated.
Do not lean the ladder against
unsuitable surfaces.
Ladder shall never be moved from the top.
Do not stand on the top three steps/
rungs of a leaning ladder.
Do not step off the side of standing
ladder onto another surface.
Open the ladder fully before use.
Standing ladders shall not be used
as a leaning ladder unless it is
designed to do so.
Do not stand on the top two steps/
rungs of a standing ladder without
a platform and a hand/knee rail.
Locking devices shall be checked
and be fully secured before use if
not operated automatically.
Secure the single ladder only with
the safety joint facing inwards.
en
21