Frost Protection; Settings; Automatic Switch-Off - Siemens TI 303 Mode D'emploi

en Settings

Frost protection

To prevent frost damage during
transportation and storage, the
appliance must be completely emptied
beforehand.
Info: The appliance must be ready for
use and the water tank filled.
Place a large container under the
1.
outlet of the milk frother and push
the frother down.
Press the milk button.
2.
The LED in the button flashes, and
the appliance now heats up.
As soon as steam escapes from the
3.
milk frother, remove the water tank.
Allow the appliance to cool down.
4.
Wait until ) "Water tank empty"
appears.
Use the k button to switch the
5.
appliance off.
Empty the water tank and the drip
6.
tray.
16
1

Settings

This appliance has different factory
S e t t i n g s
settings. You can customise the settings
on the appliance.
If no button is pressed within
Note:
90 seconds, the appliance switches to
"Choose beverage" without saving. The
previous setting remains unchanged.
You can select the following settings:

Automatic switch-off

The appliance switches off automatically
i c s w i t c h - o f f S e l e c t i n g a u t o m a t
at a specific time after the last button
was pressed. This time can be selected,
with settings from 15 minutes to
4 hours possible here.
Press and hold % and
1.
calc'nClean for at least 3 seconds.
Touch the "V" button
2.
cappuccinorepeatedly until "Auto
Stand-by" appears.
Confirm by pressing the "ok" button
3.
latte macchiato.
The setting is saved.
Touch the "V" button cappuccino
4.
and select the time. The following
settings are possible:
after 15 min.
–
after 30 min. (factory setting)
–
after 1 hour
–
after 2 hours
–
after 4 hours
–
Confirm by pressing the "ok" button
5.
latte macchiato.
The setting is saved.
Touch the "¾" button caffe crema to
6.
exit the menu.