Frost Protection; Accessories - Siemens TE503 Serie Mode D'emploi

en
Calc'n'Clean in progress
The descaling pro gramme will now run for
about 12 minutes�
Clean / Fill water tank
Press start
● Rinse the water tank (16) and refill it
with fresh water up to the max mark�
● Press the start button (10)�
Calc'n'Clean in progress
The descaling pro gramme now runs for
about 30 seconds and rinses the appliance�
Push milk frother
● Push the milk frother (6) in to close it�
Calc'n'Clean in progress
The cleaning pro gramme will now run for
about 8 minutes�
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them�
Replace the filter if one is being used. The
appliance has finished cleaning is ready for
use again�
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue� Such residue can
cause corrosion� New sponge cloths may
contain salts. Salts can cause rust film
on stainless steel and must therefore be
washed out thoroughly before use�
38

Frost protection

A
To avoid damage from low
temperatures during transport and
storage, the appliance must be
completely emptied first.
Note: The appliance must be ready for use
and the water tank (16) filled.
1� Place a large receptacle under outlet
(6c)�
h
2� Press the button (11)�
h
The button (11) flashes and the
appliance now heats up for approx.
20 seconds� The display then shows
Pull milk frother
3� Open the milk frother (6) by pulling
it out and release steam for about
15 seconds�
4� Switch the appliance off at the power
on/off switch O / I (9)�
5� Empty the water tank (16) and the
drip tray (8)�

Accessories

The following accessories can be obtained
from retailers and customer service�
Accessories
Cleaning tablets
Descaling tablets
Water filter
Care set
Milk container with
"Fresh Lock" lid
�
Ordering number
Retail /
Customer service
TZ60001
00310575
TZ80002
00576693
TZ70003
00575491
TZ80004
00576330
TZ80009N
00576166