Siemens TI 303 Mode D'emploi page 26

en Trouble shooting
Display shows "Fill water tank"
despite full water tank.
Display shows "Fill water tank"
and LEDs flashing.
Display shows "Clean brewing
unit".
Display shows "Incorrect volt-
age".
Display shows "Device too
cold".
Display shows "Restart appli-
ance", LEDs flashing.
Display shows "Restart appli-
ance"; LED does not light up.
If you are unable to solve the problem, always call the hotline.
You will find the telephone numbers at the back of these instructions
--------
26
Water tank wrongly inserted.
Carbonated water in the water
tank.
Float is stuck in the water tank. Remove the water tank and clean thor-
New water filter not rinsed
according to the instructions.
Air in the water filter.
Water filter is old.
Water tank is missing or not
inserted correctly.
The pipe system in the appli-
ance is dry.
Air in the water filter.
Brewing unit is soiled.
The brewing unit's mechanism
is stiff.
Incorrect voltage in building.
The ambient temperature is too
cold.
Brewing unit very heavily
soiled, or brewing unit cannot
be removed.
Fault in the appliance.
Insert water tank correctly.
Fill the water tank with fresh tap water.
oughly.
Rinse the water filter according to the
instructions and then switch on.
Immerse the water filter (opening up)
in water until no more air bubbles
escape; insert the filter again.
~ "Inserting or replacing a water
filter" on page 15
Insert a new water filter.
Insert water tank correctly.
Fill the water tank with fresh tap water.
Do not fill up with carbonated water.
Immerse the water filter (opening up)
in water until no more air bubbles
escape; insert the filter again.
Clean the brewing unit.
Clean the brewing unit. ~ "Daily care
and cleaning" on page 19
Operate the appliance at 220V-240V
only.
Operate the appliance at temperatures
>5°C.
Switch the appliance off and back on
again. Clean brewing unit if possible.
Restart appliance.