Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Maintenance
OVEN DOOR
CAUTION:
➢ Do not place excessive weight on or
stand on an open oven door. This could
cause the range to tip over, break the
door, or injure the user.
➢ Do not attempt to open or close door or
operate oven until door is properly re-
placed.
➢ Never place fingers between hinge and
front oven frame. Hinge arms are spring
mounted. If accidentally hit, the hinge
will slam shut against oven frame and
could injure your fingers.
TO REMOVE:
1. When cool, open the oven door to the broil
stop position (opened about four inches).
2. Grasp door at each side. Do not use the
door handle to lift door.
3. Lift up evenly until door clears hinge arms.
TO REPLACE:
1. Grasp door at each side.
2. Align slots in the door with the hinge arms
on the range.
3. Slide the door down onto the hinge arms
until the door is completely seated on the
hinges. Push down on the top corners of
the door to completely seat door on hinges.
Door should not appear crooked.
NOTE: The oven door on a new range may
feel "spongy" when it is closed. This is normal
and will decrease with use.
OVEN WINDOW
(
)
SELECT MODELS
To protect the oven door window:
1. Do not use abrasive cleaning agents
such as steel wool scouring pads or pow-
dered cleansers as they may scratch the
glass.
2. Do not hit the glass with pots, pans,
furniture, toys, or other objects.
3. Do not close the oven door until the oven
racks are in place.
Scratching, hitting, jarring or stressing the
glass may weaken its structure causing an
increased risk of breakage at a later date.
OVEN LIGHT
CAUTION:
➢ Disconnect power to range before
replacing light bulb.
➢ Use a dry potholder to prevent pos-
sible harm to hands when replacing
bulb.
➢ Make sure bulb is cool before touch-
ing bulb.
➢ Do not touch hot bulb with a damp
cloth as this may cause the bulb to
break.
BULB COVER
WIRE
RETAINER
TO REPLACE OVEN LIGHT BULB:
1. When oven is cool, hold bulb cover in
place, then slide wire retainer off cover.
NOTE: Bulb cover will fall if not held in
place while removing wire retainer.
2. Remove bulb cover and light bulb.
3. Replace with a 40 watt appliance bulb.
4. Replace bulb cover and secure with wire
retainer.
5. Reconnect power to the range. Reset
clock.
LEVELING LEGS
CAUTION:
➢ Be sure the anti-tip bracket secures
one of the rear leveling legs to the floor.
This bracket prevents the range from
accidentally tipping.
The range should be leveled
when installed. If the range is
not level, turn the plastic level-
ing legs, located at each
corner of the range,
until range is
level.
LEVELING LEG
STORAGE DRAWER
CAUTION:
➢ Do not store plastic, paper products,
food or flammable materials in this
drawer. The drawer may become too
warm for these items when the oven
is in use.
The storage drawer can be removed to allow
you to clean under the range.
TO REMOVE:
1. Empty drawer and pull out to the first stop
position.
2. Lift up the front of the drawer.
3. Pull out to the second stop position.
4. Grasp sides and lift drawer up and out.
TO REPLACE:
1. Fit the ends of the drawer glides into the
rails in the range.
2. Lift up the front of the drawer and gently
push in to the first stop position.
3. Lift drawer up again and push until drawer
is closed.
ANTI-TIP
ANTI-TIP BRACK
BRACKET
14
Publicité
Table des Matières
