Transport And Interim Storage; Product Data; Technical Data - Wilo AlarmControl Notice De Montage Et De Mise En Service

English

3 Transport and interim storage

On receipt of the product, check it for any damage incurred in transit. In the
event of damage in transit, the necessary steps must be taken with the carrier
before the relevant deadlines.
CAUTION! Danger of damage to the switchgear
Danger of damage due to improper handling during transport and storage.
• The switchgear must be protected against moisture and mechanical damage
caused by blows/impact.
• It must not be exposed to temperatures outside the range –20°C to +60°C.
4 Application
WARNING! Danger of personal injury
The alarm switchgear is not explosion-protected.
• Do not install or use the switchgear in potentially explosive areas.
The AlarmControl switchgear emits a warning signal if the water level is too high
in
• Pump shafts
• Lifting units
• Tanks.
A 9V storage battery (included in the scope of supply) is installed so that it can
operate independently of the main power supply.

5 Product data

5.1 Technical data

AlarmControl 1-2
Operating voltage
Frequency
Control voltage
Standby auxiliary power demand
Alarm contact: (AlarmControl only 1)
Socket contact: (AlarmControl only 2)
Protection class
Float switch cable length
Dimensions:
Housing
Temperature range
12
1 ~ 230 V
50/60 Hz
12 V DC (unstabilised)
< 1.5 W
Potential-free normally open contact,
Max. contact load 1 A (230V AC)
Max. contact load 16 A (250V AC)
IP 20
3 m (2 x 0.75mm²)
Length 112 mm
Width 68 mm
Height 53 mm (without plug)
ABS
-20 °C to +60 °C
Wilo SE 04/2009