Safety Instructions For Inspection And Installation Work; Unauthorised Modification And Manufacture Of Spare Parts; Improper Use; Transport And Interim Storage - Wilo SC-Booster SC Notice De Montage Et De Mise En Service

English
2.5 Safety instructions for inspection and
installation work
The operator must ensure that all installation and
maintenance work is carried out by authorised and
qualified personnel, who are sufficiently informed
from their own detailed study of the operating
instructions.
Work on the product/unit must only be carried out
when at a standstill. It is mandatory that the pro-
cedure described in the installation and operating
instructions for shutting down the product/unit
are complied with.
Immediately on conclusion of the work, all safety
and protective devices must be put back in posi-
tion and/or recommissioned.
2.6 Unauthorised modification and manufacture of
spare parts
Unauthorised modification and manufacture of
spare parts will impair the safety of the product/
personnel and will make void the manufacturer's
declarations regarding safety.
Modifications to the product are only permissible
after consultation with the manufacturer. Original
spare parts and accessories authorised by the
manufacturer ensure safety. The use of other
parts will absolve us of liability for consequential
events.

2.7 Improper use

The operating safety of the supplied product is
only guaranteed for conventional use in accord-
ance with Section 4 of the operating instructions.
The limit values must on no account fall under or
exceed those specified in the catalogue/data
sheet.
40

3 Transport and interim storage

Immediately after receiving the product:
• Check the product for damage in transit.
• In the event of damage in transit, take the neces-
sary steps with the forwarding agent within the
respective time limits.
CAUTION! Risk of damage to property!
Incorrect transport and interim storage can
cause damage to the product.
• The switchgear is to be protected against mois-
ture and mechanical damage.
• It must not be exposed to temperatures outside
the range from -10 °C to +50 °C.

4 Application (intended use)

The SC switchgear is used for automatic, conven-
ient control of pressure boosting systems (indi-
vidual and multi-pump systems).
The field of application is the water supply in res-
idential towers, hotels, hospitals, offices and
industrial buildings.
When used in conjunction with suitable signal
transmitters, the pumps offer low-noise and
energy-saving operation. The performance of the
pumps is adapted to the constantly changing
requirements in the water-supply system.
Intended use also includes following these
instructions.
Any use above and beyond these is regarded as
improper use.
WILO SE 01/2013