Troubleshooting - Grizzly GHS 2842 B Traduction De La Notice D'utilisation Originale

GB

Troubleshooting

Problem
Motor not run-
ning or cuts out
during operation
Garden waste
is not drawn in
Shredding
material comes
out in chains
86
Possible cause
Collection box
incorrectly attached
Overload protection
No mains power supply
Safety switch is not
properly in place on the
collector box
Cylinder running in
reverse
Shredding material is too
soft
cylinder is jammed
Pressure plate is incorrectly
adjusted
Remedy
Push the collection box
home to its correct
position, and place the
safety switch on the box to
the ON position.
To switch back on, start by turning the
operating mode selection switch (
to the "OFF" position.
Press the reset switch (
Switch the device back on.
Check the socket, cable, lead and
plug for damage, and if necessary,
have any damage repaired by
qualified repair personnel.
Move the safety switch into
the ON position (see
section on emptying the
collector box)
Change rotational direction using
the switch
Insert wood or shred dried branches
Free up the jam
(See section on working methods)
Readjust the pressure plate (See
section on working methods)
9)
A
7).
A