Technical Specifications - Grizzly GHS 2842 B Traduction De La Notice D'utilisation Originale

to give you a cost estimate.
We can only repair equipment with
sufficient postage and packaging by
the sender.
• We will not accept bulk consign-
ments, express or other special
freight where postage has not been
paid for.
• We will dispose of your equipment
free of charge.

Technical specifications

Silent shredder ...................GHS 2842B
Nominal power intake .......2800 W
Nominal voltage .. 220 V-240 V AC, 50 Hz
Safety class .......................................
Degree of protection .........................IP24
Branch thickness ................Max 42 mm**
Collector box content ............. Approx 60 l
Weight ............................................ 22 kg
Sound pressure level (L
................................. 83 dB(A); K
Sound power level
Measured (L )
WA
................................96 dB(A); K
Guaranteed ............................... 99 dB(A)
* Continuous-operation periodic duty
(4 min on - 6 min idle)
* * The max. branch thickness that can be chaffed is
dependent on the type of wood and the quality of
the goods being cut.
For hard wood (e.g. oak/beech branches), the
max. branch thickness that can be chaffed is less
than for soft wood (e.g. pine/spruce wood). For
dry or knotted wood, the cutting thickness may
also be less.
Do not exceed the maximum permitted
network impedance of 0.28 Ohms at the
electrical connection point. The user must
ensure that the device is operated only
on a power supply network that fulfils this
requirement.
(P40)*
II
)
pA
= 3 dB
pA
= 3 dB
WA
If necessary, the local power supply com-
pany can be asked for the system imped-
ance.
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration
of conformity.
Technical and optical changes can be car-
ried out in the course of further develop-
ment without notice. All dimensions, refer-
ences and information of this instruction
manual are therefore without guarantee.
Legal claims, which are made on the ba-
sis of the instruction manual, cannot thus
be considered as valid.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Safety precautions aimed at pro-
tecting the user should be based
on estimated exposure under
actual usage conditions (all parts
of the operating cycle are to be
considered, including, for example,
times during which the power tool
is turned off and times when the
tool is turned on but is running
idle).
GB
85