Freeing Up A Jam; Adjusting The Pressure Plate - Grizzly GHS 2842 B Traduction De La Notice D'utilisation Originale

• Before you shred roots, remove any
remaining soil and stones from them
• Do not shred soft, damp material such
as kitchen waste, but take it straight to
the compost.
• Keep a few dry branches for the end,
as they will help clean the shredder.
• Only switch the shredder off when all
of the shredding material has passed
through the cylinder. Otherwise, the
cylinder may jam the next time you
switch the shredder on.

Freeing up a jam

• Push back the operating mode selec-
tion switch (
A
operating mode selection switch to the
left.
The operating mode selection switch
does not lock into place.
1
Jammed chopping material is released.
The direction of rotation is to be changed
only until the chopping material is re-
leased.
• For stubborn blockages, the distance
of the pressure plate from the blade
cylinder can be increased by turning
the adjusting screw (
wise. To switch the device back on,
turn the operating mode selection
switch ( 2). When the jammed chop-
A
ping material has been released, the
pressure plate must be readjusted
by turning the adjusting screw (
clockwise.
2) lock and turn the
2
8) anticlock-
A
A
Exceptionally, if this process fails
to remove the blockage, the follow-
ing option remains:
1. Remove the four Allen screw
(15) on the housing plate (16).
2 Take off the housing plate. This
may require light jerking move-
ments, as the housing plate also
contains two counter bearings.
3. The blockage can now be remo-
ved from the equipment.
4. When replacing the housing
plate (16), ensure that it is po-
sitioned correctly. This is deter-
mined by the blade shaft (17),
pressure plate rod (18) and four
threads.
5. Screw on the housing plate (16)
firmly with the four Allen screws
(15).

Adjusting the pressure plate

You will recognise that the cutting system
has become worn when the shredding
material is only compressed, and comes
out in long chains.
The running-in process may require that
you initially readjust the pressure plate in
short intervals.
1. To switch on the equipment, turn the
operating mode selection switch (
to the right.
2. Turn the adjusting screw (
clockwise until you hear scraping
noises. Small aluminium shavings will
come out of the ejection chute.
Avoid unnecessary wear on the
pressure plate by not over-adju-
8) sting.
GB
2)
A
8) slowly
A
83