Loop Attachment & Detachment; Attach The Loops (5 Steps); Apply The Walking Jacket; Detach The Loops (2 Steps) - arjo MAA5000 Mode D'emploi

Loop Attachment & Detachment
2 point spreader bar:

Attach the Loops (5 Steps)

WARNING
Use the same loop length and loop colour
on the straps for both shoulders.
EN
Place the loop over the spring loaded latch (A
(See Fig. 3 )
Make sure that the spring loaded latch closes
NOTE
• The loops lengths on the straps are used to
adjust the resident's position and comfort.

Apply the Walking Jacket

In Chair/Wheelchair (22 steps)
WARNING
Do not cross the shoulder straps.
Place the Walking Jacket
Position the back of the jacket as far down as
the jacket has two loops positioned at waist level
WARNING
To avoid injury when using a Walking
Jacket, make sure the belt is pulled through
Place the support belt around the resident's back
Fig. 3
(See Fig. 3 )
IFU
Fig. 4
A

Detach the Loops (2 steps)

Make sure that the weight of the resident is taken up
Method 1
Method 2
Pull one side of the loop over the hook and spring
(See Fig. 4 )
front of the Walking Jacket
black straps on the back of the Walking Jacket
(See Fig. 7 )
straps should be tight but comfortable for the
Continue with the steps on the next page.
Fig. 5 Fig. 6
6
(See Fig. 5)
(See Fig. 6 )
Fig. 7