Allowed Combinations; Clip Attachment & Detachment; Warning - arjo Sara 3000 Mode D'emploi

Allowed Combinations

WARNING

To avoid injury, always follow the allowed combinations listed in this IFU. No other
combinations are allowed.
Safe Working Load (SWL)
WARNING
Always follow the lowest SWL in the complete system (lift or sling).
• Only use the earlier listed slings with the
• The SWL of the
• Always follow the lowest SWL in the complete system. E.g. the
Flites has the lowest SWL. The patient is not allowed to weigh more than the lowest SWL.
Standing/
Raising Aid
SWL
Active Sling SWL
MFA3000
TSS.500-503W
TSS.500-503S-1C
TSS.500-504
TSS.501-502SV
TSS.501-503A
TSS.511
MAA3060M
MAA3061M
MAA3070M
MAA3071M
Clip Attachment & Detachment
Attach the Clips (6 steps)
1. Select the inner or outer attachment clips.
2. Place the clip on the spreader bar lug.
(See Fig. 5 )
3. Pull the strap down.
4. Make sure the lug is locked at the top end
of the clip. (See Fig. 6 )
5. Make sure the strap is not squeezed
in between the clip and the spreader bar.
6. Make sure the straps are not twisted.
Fig. 5
Sara 3000,
Sara Flex
Size Size
One size One size
S, M, L, XL –
S, M, L, XL S, M, L, XL
S, M, L, XL, XXL S, M, L, XL, XXL
M,L M,L
M, L, XL M, L, XL
One size –
One size –
One size –
One size One size
One size One size
Detach the Clips (3 steps)
Make sure that the weight of the patient is taken
up by the receiving surface before removing
the clip.
1. Pull the strap up. (See Fig. 7 )
2. Make sure the lug is unlocked
at the bottom of the clip.
3. Remove the clip.
Fig. 6
9
/Flex standing and raising aid.
is 175 kg
lift has a SWL of 200
Sara Lite Sara Stedy
Size
One size
S, M, L, XL
S, M, L, XL
S, M, L, XL, XXL
M,L
M, L, XL
–
–
–
One size
One size
Fig. 7
EN