Turning On; Simmer Setting; Electronic Flame Monitoring And Automatic Re-Ignition; Turning Off - Gaggenau VG 491 211 CA Notice D'utilisation

en-us
Operating the appliance

Turning on

Your gas cooktop has an automatic quick-ignition
function.
1.
Place a suitable item of cookware on the pan support.
2.
Push in the control knob for your chosen burner and
turn it clockwise or counter-clockwise to the heat
setting you require.
The burner ignites automatically.
Turn the control knob to set the heat setting.
9
WARNING
Risk of deflagration!
If the burner does not ignite after 15 seconds,
switch off the control knob and open the door or
window in the room. Wait at least 1 minute before
igniting the burner again.

Simmer setting

With the simmer setting, the burner switches the gas
flame on and off. This allows you to melt chocolate or
heat up delicate sauces, for example.
Turn the control knob to Â. It takes 10-50 seconds to
switch on or off.
16
Electronic flame monitoring and
automatic re-ignition
For your safety, the cooktop has an electronic flame
monitoring system. If the flame goes out while the
cooktop is in use (e.g. due to a draft), the appliance will
automatically re-ignite the burner.
If re-ignition is unsuccessful (e.g. because liquid or food
has boiled over and remains on the burner), the
appliance will switch off the gas supply. The illuminated
ring behind the control knob will flash.
Turn the control knob to 0. Wait until the appliance is
cool enough and then check whether all the burner parts
are in the correct position. Check whether the burner or
the ignition plug are covered in food remnants
etc.~ "Faults – What to Do?" on page 20

Turning off

Turn the control knob to position 0. The appliance
electronics will shut off the gas supply.

Residual heat display

The illuminated ring behind the control knob will flash
after switching off as long as the appliance is too hot to
touch it safely.

Safety shut-off

For your protection, the appliance is equipped with a
safety shut-off. The appliance is automatically switched
off if it has been in operation for an extended period.
How long the appliance waits before switching itself off
depends on the setting (setting 12 = 1 hour, setting 1 =
4 hours). The illuminated ring behind the control knob
will flash orange and white alternately.
Turn the control knob to 0. You will now be able to start
the appliance again as usual.