Operating The Internal Cdr - Dedicated Micros ECO 9 Guide D'installation

Activity grid
An 8 x 16 grid is used to mask areas where activity detection is enabled. When
the grid is displayed, use the cursor keys to move the cursor to the desired
location and press a camera key to toggle the block on (white dot) or off.
Activity test
Use this option to test and tune the sensitivity and activity grid set up for each
camera. When activity is detected on the camera a white dot is displayed.
Press the Mode/Menu key to exit the test.
22

Operating the Internal CDR

The Eco9 with integrated CD operates in exactly the same way as the Eco9
and offers a built in CD writer allowing for simple and easy archiving of
recorded images. The CD writer is accessible from the front of the Eco9.
The operation of the internal CDR is identical to using the external CDR as
described on the Eco9 Operator Guide.
Note: Although the CDR drive may have a DVD-ROM label on the drawer it is
not possible to read or write to DVD media. To insert a CDR:
1. Press the button on the CDR drawer
2. Pull the CD drawer out until there is resistance
3. Place the CDR with the writing side up on the spindle and press down until
there is a click.
4. Push the drawer back in until it latches.
To remove a CDR:
1. Press the button on the CDR drawer
2. Pull the CD drawer out until there is resistance
3. Hold the CDR between thumb and forefinger and lift to remove from the
spindle.
4. Push the drawer back in until it latches.
Note: In the event of a CD becoming jammed in the drive, or a power failure, it
is possible to open the CDR drawer by inserting a thin object such as a paper
clip, or watchmaker's screwdriver into the small hole in the CDR drawer and
applying pressure until the drawer unlocks.
WARNING: The CDR is a Class 1 laser product to EN 60825-1:1994, avoid
exposure to the beam.