System Options - Dedicated Micros ECO 9 Guide D'installation

System Options

User password
A password can be set to prohibit unauthorised access to the menu systems.
The default setting is Off.
To set or change the menu password:
1. Use the cursor keys to change the User password to On.
2. When the new password menu is displayed use the camera key numbers to
enter a password - up to eight numbers.
3. Press the Mode/Menu key to enter the password.
4. When prompted re-enter the password to confirm and press the
Mode/Menu key when complete.
WARNING: For security reasons, loss of passwords will require the unit to be
returned for the passwords to be reset.
Make a note of your password here __ __ __ __ __ __ __ __
Network settings
This option is used to configure the unit for connection to an Ethernet network
or dial-up. A pop-up box for configuring the network settings is displayed with
the following items:
16
System name
Each Eco9 on the network can be given a system name to help identification,
the unit name is displayed in the Network Viewing software. A maximum of 30
characters can be used for the system name. The default unit name is 'Eco9'.
Tip: If you do not want the unit to automatically identify itself on a network, use
a '#' symbol as the first character. You will still able to access the unit across
the network by typing in the IP address directly into the Network Viewing
software.
Network
This option is used to enable or disable the network option. The network is
enabled by default.
TCP/IP address, Subnet mask, Default gateway
A unique IP address and a subnet mask must be given to the Eco9 in order to
communicate with it over a network. On an existing network these are often
obtained from the network administrator. A Default gateway will be required if
the Eco9 is going to be viewed from a remote location, such as a WAN or dial-
up via a router.
Note: The Eco9 requires a Static IP address, even if it is connected to a
dynamic (DHCP) network.