Factory Default - Dedicated Micros ECO 9 Guide D'installation

Warning: Changing the MTU size can have an adverse affect on the
transmission speed and operation over the network. Check with your network
administrator or service provider for advice on the correct MTU size for the
network.
Bandwidth limit
The bandwidth used by the Eco9 can be limited to prevent overloading on
slower networks. The Eco9 has a 10MB/s connection (10Base-T).
The maximum bandwidth that an Eco9 will use (5 users viewing images) is
6Mb/s (006000Kbits/s) so any limiting over 60% does not affect the bandwidth
used by the Eco9. The maximum bandwidth used by one user is approximately
2.5Mb/s
If you want to limit the bandwidth used by the Eco9 to 1Mb/s set the bandwidth
limit to 001000Kbits/s, the equivalent KBytes/second will automatically be
calculated.
Note: Restricting the bandwidth does not decrease the image quality, but the
update rate of the images over the network will decrease.
Modem initialise
Note: Serial port 1 is always initialised for PPP connection using a US
Robotics modem.
This text string will be transmitted from the Eco9 to the modem on a regular
interval to ensure communication is still present. It is also the string that would
be used for 'dial in' for the PPP function.
18
PPP address
The PPP (Point to Point Protocol) address is used when a Hayes compatible
modem is connected to the Eco9. The PPP address must be entered into the
Network Viewing software or Web browser to view images when connected to
the Eco9.
By default, the PPP address is 172.017.002.002 when the TCP/IP address is at
its default setting of 000.000.000.000. The PPP address cannot be changed
directly, but is changed automatically when the TCP/IP address is adjusted.

Factory default

Use this option to return all settings to the factory condition.