Transportation And Storage; Inspect The Delivery; Transportation Guidelines; Storage Guidelines - Lowara ResiBoost MMW Manuel D'installation Et D'entretien

en - Original instructions
(frequency converter) for
electric pumps (see label on
first page)
5. The object of the declaration described above is
in conformity with Directive 2011/65/EU of the Euro-
pean Parliament and of the Council of 8 June 2011
on the restriction of the use of certain hazardous
substances in electrical and electronic equipment.
6. Where applicable, EN 50581:2012
references to the rel-
evant harmonised
standards used or
references to the
technical specifica-
tions in relation to
which conformity is
declared:
7. Additional informa- ---
tion:
Signed for and on be- Xylem Service Italia S.r.l.
half of:
Montecchio Mag-
giore, 04.12.2019
Amedeo Valente
(Director of Engineer-
ing and R&D)
Rev. 00
Lowara is a trademark of Xylem Inc. or one of its
subsidiaries.

2 Transportation and Storage

2.1 Inspect the delivery

1. Check the outside of the package.
2. Notify our distributor within eight days of the de-
livery date, if the product bears visible signs of
damage.
3. Open the carton.
4. Remove packing materials from the product.
Dispose of all packing materials in accordance
with local regulations.
5. Inspect the product to determine if any parts
have been damaged or are missing.
6. Contact the seller if anything is out of order.

2.2 Transportation guidelines

Precautions
WARNING:
• Observe accident prevention regula-
tions in force.
• Crush hazard. The unit and the com-
ponents can be heavy. Use proper
lifting methods and wear steel-toed
shoes at all times.
Check the gross weight that is indicated on the
package in order to select proper lifting equipment.
Position and fastening
26
The unit must be transported only in its horizontal
position as indicated on the package. Make sure that
the unit is securely fastened during transportation
and cannot roll or fall over. The product must be
transported at an ambient temperature from -10°C to
70°C (14°F to 158°F) with a non-condensing humidi-
ty of <95% and protected against dirt, heat source,
and mechanical damage.

2.3 Storage guidelines

2.3.1 Storage location

NOTICE:
• Protect the product against humidity, dirt, heat
sources, and mechanical damage.
• The product must be stored at an ambient tem-
perature between 10°C and 70°C (14°F and
158°F) and a non-condensing humidity below
95%.
• The converter uses electrolytic capacitors which
can deteriorate when not used for a long period
of time. If storing for a year or more, make sure
to run them occasionally to prevent deterioration.

3 Product Description

3.1 Product overview

™
ResiBoost is a variable frequency driver (convert-
er) intended to be used with an electric pump for
constant pressure systems.
Not suitable for drainage systems with/without level
control.
A water system is only occasionally required to run
at maximum capacity and the amount of water with-
drawn varies over time.
™
ResiBoost automatically controls the speed of the
electric pump while keeping the pressure in the sys-
tem constant in relation to the signal of the pressure
transmitter (sensor).
3.2 Product denomination
Example: ResiBoost MMW09DE
ResiBoost
M
M
W
09
Serial name of the con-
verter
Mains power supply
M: single-phase
1x230Vac
Pump motor power sup-
ply
M: single-phase
1x230Vac
T: three-phase
3x230Vac
W: Converter installed on
the delivery line of the
pump and cooled with
water.
A: Wall-mounted con-
verter cooled with air.
Nominal current supplied
by the converter.