Mounting The Converter; Mounting Instructions - Dometic PerfectCharge DC 08 Instructions De Montage Et De Service

PerfectCharge/PerfectPower
6

Mounting the converter

6.1

Mounting instructions

If you wish to mount the converter in a fixed position, please observe the following
mounting instructions:
• You can mount the device either horizontally or vertically.
• Do not mount the device
– In wet or damp environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions
• The place of installation must be well-ventilated. A ventilation system must be
present for installations in small, closed spaces. The minimum clearance around
the device must be at least 5 cm (fig. 2, page 3).
• The air intake on the underside or the air outlet on the back of the device must
remain clear.
• For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the device under load can lead
to the automatic shut-down.
• The installation surface must be level and sufficiently sturdy.
A
NOTICE!
Before drilling any holes, ensure that no electrical cables or other parts
of the vehicle can be damaged by drilling, sawing and filing.
6.2 Mounting the converter
➤ Hold the converter against the installation location and mark the fastening points
(fig. 3 A, page 3).
➤ Fasten the converter using your chosen method (fig. 3 B, page 3).
EN
Mounting the converter
13