Technical Description; Installing The Device - Dometic BUTTNER MT PL 300 SI Instructions De Montage Et De Service

This product is only suitable for the intended pur-
pose and application in accordance with these
instructions.
This manual provides information that is necessary
for proper installation and/or operation of the
product. Poor installation and/or improper operat-
ing or maintenance will result in unsatisfactory per-
formance and a possible failure.
The manufacturer accepts no liability for any injury
or damage to the product resulting from:
• Incorrect assembly or connection, including
excess voltage
• Incorrect maintenance or use of spare parts
other than original spare parts provided by the
manufacturer
• Alterations to the product without express per-
mission from the manufacturer
• Use for purposes other than those described in
this manual
Dometic reserves the right to change product
appearance and product specifications.

Technical description

The device is a DC to AC true sine wave inverter.
Additionally, the device offers features like:
• Integrated microprocessor
• Crystal-stabilized AC output
• Electric and thermal overload protection
• Low voltage protection
• Overvoltage protection
• Temperature-controlled fan

Installing the device

Mounting instructions
• The device can be mounted horizontally or verti-
cally. Mounting the device upside down is not
allowed (fig. 6, page 5).
• For proper cooling, leave - at least - 100 mm free
space around all sides of the device (fig. 5,
page 5).
• The remote control should be installed in an
accessible place.
12
Mounting the device
A
NOTICE! Damage hazard
Before drilling any holes, make sure that
no electrical cables or other parts of the
vehicle can be damaged by drilling, saw-
ing and filing.
1. Mark and drill 8 holes on the mounting surface
(fig. 7, page 6).
2. Fasten the device securely (fig. 7, page 6).
Mounting the remote control
A
NOTICE! Damage hazard
Before drilling any holes, make sure that
no electrical cables or other parts of the
vehicle can be damaged by drilling, saw-
ing and filing.
1. Cut out the mounting surface (fig. 2,
page 3).
2. Connect the remote control using the cable
(fig. 1, page 3, 5).
3. Install the remote control.
Connecting the device
1. Lay all the necessary lines.
2. Use cable with cross-section of 4 mm2 to con-
nect the grounding connection of the device
to the ground.
3. Secure all lines with strain relief clamps.
4. Connect the device (fig. 1, page 3).
A
NOTICE! Damage hazard
Battery cables must not be connected to
the battery in reverse polarity, otherwise
damage to the device may occur.
fig. 1,
page 3
1
2
3
4
5
4445103623
Description
Inverter
Red cable
Black cable
Battery
Remote control
with fuse