General Safety Instructions For Gardening Tools; Technical Safety; Notes; Preparation - IKRA EV 1300 Manuel D'utilisation

Keep supply cord away from the cutting device.
Cutting device continues to rotate after the product is switched off. Wait until all components have
completely stopped before touching the product.
Objects thrown by the product could hit the user or other bystanders.
Always ensure that other people and pets remain at a safe distance from the product when it is in
operation. In general, children must not come near the area where the product is.
Waste electrical products should not be disposed of with household waste, please recycle where
facilities exist. Check with your local authority or retailer for recycling advice.
Guaranteed sound power level
4. GENERAL SAFETY INSTRUCTIONS FOR
GARDENING TOOLS
WARNING – Read all safety instructions! Fail-
ure to observe the safety instructions may result
in electric shock, burns and/or severe injury.
Keep the safety instructions für future reference.
- This device is not intended to be used by persons
(incl. children) with limited physical, sensory or
mental abilities or with a lack of experience and/or
knowledge unless they are supervised by a person
responsible for their safety or were instructed on the
proper use of the device by that person.
- Children should be under supervision to ensure that
they do not play with the device.

Technical safety

Notes

a) Read the Operating Instructions carefully. Make sure
to be thoroughly familiar with the controls and proper
use of the tool.

Preparation

a) Never allow children or other persons that are not
familiar with the Operating Instructions to use the
tool. The minimum age for operating the tool may be
determined by local regulations.
b) Do not operate the tool while other persons – in par-
ticular children – or animals are nearby.
c) Keep in mind that the operator of the tool is liable for
accidents or risks that may occur to other persons or
their property.
d) Wear ear and eye protection while operating the tool.
e) Always wear sturdy footwear and long trousers when
operating the tool. Do not operate the tool with bare
feet or open sandals.
f) Check the area, in which you are going to operate the
tool, and remove all stones, sticks, wires, bones and
other objects that may get caught and hurled away.
n) Visually inspect the work tools and bolts for signs of
wear and tear or damages each time before you start
using the tool. To avoid imbalances worn-out or dam-
aged work tools and/or bolts may only be replaced
in sets.
o) If tools with ejection openings pointing to the back-
side and uncovered rear rollers without collection or
protection devices full eye protection (safety gog-
gles) must be worn.

Handling

a) Operate the tool in daylight or good artificial lighting
only.
c) If possible avoid to use the tool with wet grass or ap-
ply particular care to avoid slipping.
GB-5