Automatic Operation (Auto Changeover) - Toshiba RAV-SM562BT-E Manuel Du Propriétaire

AUTOMATIC OPERATION (Auto Changeover)

When you set the air conditioner in
either cooling, heating, or fan only operation depending on the indoor room temperature.
3
Start
1
ON / OFF
button
Push this button to start the air conditioner.
2
Mode select button (MODE)
Select Auto.
3
Temperature button
Set the desired temperature.
• In case of cooling, start the operation after approx. 1 minute.
• In case of heating, starts the operation after approximately 3 to 5 minutes.
• When you select the Auto mode, it is unnecessary to set the fan speed.
The fan speed display will show
• After heating operation stops, FAN operation may continue for approx. 30 seconds.
• When the room temperature reaches the set temperature and the outdoor unit stops, the LOW wind is
discharged and the air volume decreases excessively.
During defrost operation, the fan stops so that cool air is not discharged and
• If the Auto mode is uncomfortable, you can select the desired conditions manually.
NOTE
When restarting the operation after stop
• When restarting the operation immediately after stop, the air conditioner does not operate for approx. 3
minutes to protect a compressor.
Stop
ON / OFF
Push button.
Push this button again to stop the air conditioner.
mode or switch over from AUTO operation, it will automatically select
TEMP.
TIMER SET
TIME
FILTER
RESET TEST SET CL
and fan speed will be automatically controlled.
7
ON / OFF
FAN MODE
SAVE VENT
SWING/FIX UNIT LOUVER
1
2
is displayed.