Automatic Operation; Automatic Operation (Auto Changeover) - Toshiba RAS-M10SMUV-E Manuel Du Propriétaire

AUTOMATIC OPERATION

When you set the air conditioner in AUTO mode, it will automatically select either cooling, heating, or fan only operation depending on
the outdoor temperature. (Refer to page 17.)
In addition, fan speed is automatically controlled.
Start
a START/STOP button
Push this button to start the air conditioner.
b AUTO button (AUTO)
Push AUTO button.
c Temperature button (
Set the desired temperature.
• The OPERATION lamp (green) on the panel of the indoor unit illuminates. The operating
mode is selected in accordance with the room temperature and the operation starts after
approximately 3 minutes.
• If the AUTO mode is uncomfortable, you can select the desired conditions manually.
• Fan speeds and louver position can be changed.
When it is changed, the MODE is also changed from AUTO to A.
At the same time, fan speed indication is displayed.
Stop
START/STOP button
Push this button to stop the air conditioner.

AUTOMATIC OPERATION (AUTO CHANGEOVER)

When you set the air conditioner in A mode or switch over from AUTO operation because setting may have been changed, it will
automatically select either cooling, heating or fan only operation depending on the outdoor temperature. (Refer to page 17.)
Start
a START/STOP button
Push this button to start the air conditioner.
b Mode select button (MODE)
Select A.
c Temperature button (
Set the desired temperature.
d Fan speed button (FAN)
Select one of "AUTO", LOW
• The OPERATION indicator (green) on the panel of the indoor unit illuminates. The
operating mode is selected according to the room temperature and operation starts
after approximately 3 minutes.
• The temperature, fan speeds and louver position can be changed. You can select the
desired conditions manually.
Stop
START/STOP button
Push this button to stop the air conditioner.
EN
)
)
, LOW+ , MED , MED+ , HIGH
10
.