Cooling/Heating/Fan Only Operation; Dry Operation - Toshiba RAS-M10SMUV-E Manuel Du Propriétaire

COOLING/HEATING/FAN ONLY OPERATION

Start
a START/STOP button
Push this button to start the air conditioner.
b Mode select button (MODE)
Select Cool , Heat
(For cooling only models)
c Temperature button (
Set the desired temperature.
When the air conditioner is in FAN ONLY operation, the temperature display is not
displayed. (For cooling only models)
d Fan speed button (FAN)
Select one of "AUTO", LOW
• The OPERATION lamp (green) on the panel of the indoor unit illuminates. Operation
starts after approximately 3 minutes. (If you select FAN ONLY mode, the unit will start
immediately.)
• The : Fan only mode does not control temperature.
Therefore, perform only steps a, b and d to select this mode.
Stop
START/STOP button
Push this button to stop the air conditioner.

DRY OPERATION

Start
a START/STOP button
Push this button to start the air conditioner.
b Mode select button (MODE)
Select DRY .
c Temperature button (
Set the desired temperature.
• The fan speed display indicates AUTO.
• The OPERATION lamp (green) on the panel of the indoor unit illuminates, and
operation starts after approximately 3 minutes.
Stop
START/STOP button
Push this button to stop the air conditioner.
(For heat pump models), Fan only
)
, LOW+ , MED
)
.
, MED+ , HIGH .
11 EN