Automatic Operation; Automatic Operation (Auto Changeover) - Toshiba RAS-M10GDCV-E Manuel Du Propriétaire

AUTOMATIC OPERATION

When you set the air conditioner in AUTO mode, it will automatically select either
cooling, heating, or fan only operation depending on the outdoor temperature. (Refer
to page 16.)
In addition, fan speed is automatically controlled.
Start
a AUTO button (AUTO)
Push AUTO button to start the air conditioner.
• The OPERATION lamp (green) on the switch panel of the indoor unit lights. The
operating mode is selected in accordance with the room temperature and operation
starts after approximately 3 minutes.
• If the AUTO mode is uncomfortable, you can select the desired conditions
manually.
Temperature and fan speed can be changed.
When fan speed is changed, MODE is also changed from AUTO to A.
At the same time, fan speed indication is indicated.
Stop
START/STOP button
Push this button again to stop the air conditioner.

AUTOMATIC OPERATION (AUTO CHANGEOVER)

When you set the air conditioner in A mode or switch over from AUTO operation
because of some settings change, it will automatically select either cooling, heating,
or fan only operation depending on the outdoor temperature. (Refer to page 16.)
Start
a START/STOP button
Push this button to start the air conditioner.
b Mode select button (MODE)
Select A.
c Temperature button
Set the desired temperature.
• The OPERATION lamp (green) on the switch panel of the indoor unit lights.
The operation mode is selected in accordance with the room temperature and
operation starts after approximately 3 minutes.
• When you select the A mode, it is unnecessary to set the fan speed.
The FAN speed display will show AUTO and the fan speed will be automatically
controlled.
• If the A mode is uncomfortable, you can select the desired conditions manually.
Stop
START/STOP button
Push this button again to stop the air conditioner.
EN
10